Misc
If TotalView is monitoring a router via one IP address, yet the device sends back syslog messages with a different interface’s IP address, TotalView ma...
Tue, 20 Sep, 2016 at 1:39 PM
To Help in Planning for Network Growth, Making sure that you always have free network ports available for growth is important. The Operationally Down Inte...
Thu, 19 May, 2016 at 5:20 PM
If your switch does not allow you to assign names to each interface, TotalView can allow you to assign names to each interface. Edit the IntDescription...
Tue, 20 Sep, 2016 at 1:42 PM
For some switch manufacturers, VLAN interfaces report anomalous errors. If you do not want the error rate of VLAN interfaces calculated, check the “Ign...
Tue, 20 Sep, 2016 at 1:47 PM
Interfaces can be ignored if they offer no monitoring value. Look in the C:\Program Files (x86)\PathSolutions\TotalView\IgnoreList.cfg file.
This fi...
Tue, 20 Sep, 2016 at 1:50 PM
If the configuration is set to have TotalView analyze more than the licensed number of interfaces, the Devices tab will only display the interfaces tha...
Tue, 20 Sep, 2016 at 2:00 PM
There are three different ways of ignoring interfaces.
1) IgnoreList.cfg allows you to ignore ranges of interfaces on devices.
2) IgnoreType.c...
Tue, 20 Sep, 2016 at 2:02 PM
Packets are discarded because the transmitting machine may have run out of outbound packet buffers. (Packets can’t be transmitted because they are deferre...
Fri, 20 May, 2016 at 8:18 AM
Some devices have interfaces that are virtual interfaces. These are interfaces that exist inside the device, but don’t relate to a physical plug ...
Tue, 20 Sep, 2016 at 2:07 PM
When you trunk two interfaces together, it creates a third virtual interface that is the “trunk interface”. This may also be called the “Link Aggreg...
Tue, 20 Sep, 2016 at 2:12 PM