Misc
TotalView will collect bridge/route/ARP information: Automatically Upon system startup/restart Anytime you click on “Update” in the web UI Op...
Tue, 15 May, 2018 at 9:49 AM
High CPU Usage When Polling Routing ARP Tables Using SNMP to poll large routing tables and Address Resolution Protocol (ARP) tables can cause per...
Wed, 30 Nov, 2016 at 1:20 PM
The aggregate peak backplane utilization is all of the device’s interfaces transmit and receive put together. This allows you to see when the device is wo...
Wed, 25 May, 2016 at 3:50 PM
PathSolutions TotalView has the following communications requirements to run:
The PathSolutions server should be able to send UDP requests...
Wed, 30 Nov, 2016 at 1:25 PM
PathSolutions uses SQLite as it’s database. It is fully integrated into the product.
Wed, 25 May, 2016 at 4:03 PM
Interfaces that seem to show High Error Rates on Ports on Cisco Devices usually end up being “Deferred Transmissions” and “Outbound Discards”.
The fol...
Wed, 30 Nov, 2016 at 1:35 PM
The device must be configured to support SNMP v1 or preferably SNMP v2c. If the device is unable to support either of these protocols, then it cannot ...
Wed, 30 Nov, 2016 at 1:42 PM
On Cisco switches, the GetBRIDGE program when run normally won’t show the complete bridge table. Cisco stores the bridge table using a different method, ...
Wed, 30 Nov, 2016 at 1:45 PM
When you trunk two interfaces together, it creates a third virtual interface that is the “trunk interface”. This may also be called the “Link Aggregat...
Wed, 30 Nov, 2016 at 1:48 PM