Misc

Device Debug Red X
If a network device has problems being queried, or has a thread crash (large red “X” in front of the device), you will want to create a device debug fi...
Wed, 18 Jan, 2017 at 1:53 PM
How to UnInstall TotalView
How to do a complete uninstall: Go to the control panel and choose Add/Remove Programs Select PathSolutions TotalView and choose “Uninstall” ...
Wed, 18 Jan, 2017 at 1:53 PM
Admin Rights for Totalview Installation
For the installation to complete normally, you need: In order to install software, you need local admin rights The installer will install one Windo...
Wed, 18 Jan, 2017 at 1:54 PM
Re-Directing Poll Failure Messages
Re-Directing Poll Failure Warning Messages If you don’t want the same person to receive the Poll Failure warning messages as the Daily Network Weather ...
Wed, 18 Jan, 2017 at 1:55 PM
Cisco Class Based QoS (CBQoS) Indexes Do Not Match
Cisco Class Based QoS (CBQoS) Indexes Do Not Match If TotalView is monitoring a Cisco router that has Class Based QoS configured, the internal SNMP ...
Wed, 18 Jan, 2017 at 1:55 PM
WinHttpSendRequest Error
WinHttpSendRequest error If the Config Tool, or the QuickConfig Wizard pops up with WinHttpSendRequest error 12175 when it tries to do a license che...
Wed, 18 Jan, 2017 at 1:56 PM
Moving TotalView to a new server
Have PathSolutions support (support@pathsolutions.com) clear the MAC address for the license in the license server Install PathSolutions TotalView o...
Wed, 18 Jan, 2017 at 1:57 PM
Device name shows as “none” on Devices tab
Device name shows as “none” on Devices tab  This may happen if the device does not have a configured device name, or if the device does not support ...
Wed, 18 Jan, 2017 at 1:58 PM
Extreme Switches and BridgeTables
On some models of Extreme switches, you need to enter the following command to have it show the bridge table: Summit24:9 # enable snmp dot1dTpFdbTable
Tue, 17 May, 2016 at 3:41 PM
How do you clear out the utilization statistics?
PathSolutions’ TotalView saves statistics in files in the “Data” directory where you installed the program. Each filename corresponds to a device on your ...
Tue, 17 May, 2016 at 3:44 PM