Configuration
There are three different ways of ignoring interfaces.
1) IgnoreList.cfg allows you to ignore ranges of interfaces on devices.
2) IgnoreType.cfg all...
Mon, 23 Jan, 2017 at 2:16 PM
To add Alerts on bad calls you can use the CDR tab in the Config Tool. Then click on the “Add Button” and you should see the box below
A “bad call” is u...
Mon, 23 Jan, 2017 at 2:18 PM
If the Duplex value shows a red asterisk (*) behind the label, it indicates that the duplex setting could not be read from the device because the device d...
Thu, 19 May, 2016 at 4:37 PM
When a proxy server is used instead of a firewall, the license mechanism may not be able to connect to the PathSolutions license server on the Inter...
Mon, 23 Jan, 2017 at 2:22 PM
It is very important to make sure you do not poll your devices too often, as this can add to network overhead. In general, you should poll your interface...
Mon, 17 Jul, 2017 at 10:19 AM
To check if the TotalView License is valid:
Use Config Tool – Under the License Tab, click on the Change/Validate license button. Then click on the &...
Mon, 23 Jan, 2017 at 2:29 PM
Proxy Server
Details: When a proxy server is used instead of a firewall, the license mechanism may not be able to connect to the PathSolutions license ...
Mon, 23 Jan, 2017 at 2:31 PM
Move your important PathSolutions files by going to:
C:\Program Files(86)\PathSolutions\TotalView
In your TotalView folder, copy the Data Folder,...
Mon, 23 Jan, 2017 at 2:31 PM
To Back Up your important PathSolutions files go to:
C:\Program Files(x86)\PathSolutions\TotalView
In your TotalView folder, copy the Data Folder, Not...
Mon, 23 Jan, 2017 at 2:32 PM
If a switch doesn’t allow for ports to be named on the switch itself there is a config file than can be edited so that a Description shows up under the De...
Thu, 19 May, 2016 at 4:52 PM